Installing in All in One Panel

Emporia Energy Community Support Center Hardware and Installation Installing in All in One Panel

Viewing 2 reply threads
  • Author
    Posts
    • #11087 Report Abuse
      candlelamp6
      Member

      Hi, I’d like to install the Vue 3 however I seem to have a different electrical panel than most. The mains are jumper bars connected directly to the meter. How should I go about installing the Vue 3 Main CTs? See photos below for details on my setup

       

      Photo1

       

      Photo2

       

    • #11088 Report Abuse
      Kevin @ Emporia
      Emporia Staff

      Hey candlelamp6,

      For bus-bar mains like these – we generally recommend using the Flexible Sensors to capture those since the default 200A CT’s usually won’t fit. If you want to try and fit the default CT’s on those bars, I’d probably try to slide the top part of the CT (thinner) underneath and around the back of the bus-bar, then clamping the bottom part of the CT over the front of the bar and into place. A bit hard to tell just from the pic if that’d work, but that’d probably be the easiest way to see if they’d fit.

      We’ve been out of inventory of the Flexible Sensors recently (apologies for those who’ve been looking/waiting) – however we just got some back in stock today. Trying to get the shop page updated w/ a listing very shortly, hopefully by the end of today but might be early Monday morning when that goes live. Once those are available, you can pick up a pair of those and you should be good to go.

      ~Kevin

    • #11094 Report Abuse
      candlelamp6
      Member

      Do the rogowski cakes sold on the site current work with Vue 3?

Viewing 2 reply threads
  • You must be logged in to reply to this topic.