Mounting the energy monitor in the breaker box

Emporia Energy Community › Support Center › Hardware and Installation › Mounting the energy monitor in the breaker box

Viewing 2 reply threads
  • Author
    Posts
    • July 22, 2022 at 2:39 am #8679 Report Abuse
      gokou340
      Member

      My mains come up from the bottom of the panel. To make everything clean inside the panel, I would like to mount the energy monitor at the top of the box. Is this OK with some mounting tape such as this: https://www.amazon.com/dp/B0833W1S6P?psc=1&smid=A2BVMWN8895J1B&ref_=chk_typ_imgToDp

      Thanks!

      • This topic was modified 2 years, 4 months ago by gokou340.
    • July 28, 2022 at 3:29 pm #8725 Report Abuse
      Emporia Support
      Emporia Staff

      @gokou340  Good day!

      Yes the Gen 2 can be mounted anywhere in the electrical panel.   Many customers, including myself, have installed the device at the top of the panel where there is the most room.  Using two sided tape is perfectly fine as well.

      Marty

       

       

       

    • July 29, 2022 at 5:36 pm #8733 Report Abuse
      yyzguy
      Member

      I too installed mine at the top of the panel.   I considered using mounting tape, but ultimately didn’t.  Instead, I used one of those mounting things for zip ties and wrapped the zip tie around some of the cables which holds everything in place.

  • Author
    Posts
Viewing 2 reply threads
  • You must be logged in to reply to this topic.