Emporia Community

Community Forum for Emporia

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • in reply to: Combine 2 pole reading at the same time #9680 Report Abuse
    jh26
    Member

    For my 220v circuits, I just put a sensor on one leg and them set it to multiple by 2x in the app. For your single application high load 220v circuits, that’s close enough for me.

    in reply to: Keep moment in time when changing time scale #9410 Report Abuse
    jh26
    Member

    Wow, I have exactly the same use-case!  I want to look back to when my well pump ran, and then zoom in to seconds to see how long it actually ran. It’s always been frustrating that it resets, which makes this pretty much impossible except for the most recent runs.

    in reply to: Add Voltage Reading to App #6490 Report Abuse
    jh26
    Member

    Can the clamp-on sensors even measure voltage?

    in reply to: API to pull data #6110 Report Abuse
    jh26
    Member

    Any sort of access to the raw data will do. It’s clear you have quite a number of technically talented customers. Open it up and we’ll do the work for you.

    in reply to: API to pull data #5974 Report Abuse
    jh26
    Member

    @drguns, if I had an API or even just the ability to pull the CSV file automatically instead of manually triggered, I would create a daily usage report emailed with usage and charts for each channel.  This would give me a daily health report on the well, water heater, pool, fridge, and solar system.

    If I could do this, I would also buy a second Vue for my other house.

Viewing 5 posts - 1 through 5 (of 5 total)