Emporia Community

Community Forum for Emporia

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: Installation in a small cramped box #9800 Report Abuse
    jmak209
    Member

    After some more reading I think I will get the flexible CTs as they can be unlatched and relatched. I’m going to get an external box to run everything into. Will there be an issue if I double up the white and blue wires from the connector to 1 spot in the neutral bus bar? Furthermore, I have a few double breakers, does that mean I should only run 1 50A sensor on 1 leg of the breaker?

    in reply to: Installation in a small cramped box #9798 Report Abuse
    jmak209
    Member

    I already read somewhere that the flexible CTs can be snapped apart to go around the mains and then re-snapped together. Can anyone confirm this? Also looking into the installation instructions, the flexible CTs needs to wires to go onto the neutral bus bar, but I think I maxed out after connecting the the white and blue wire to the bus bar. Is there anything I can do?

    in reply to: Introduce Yourself! #9796 Report Abuse
    jmak209
    Member

    Hi,

    I just picked up an Emporia Vue 2. I’m located in California and I just had solar installed. I was hoping to get to monitor production and consumption. Looking around for tips and advice as I begin to try to install this system.

     

    Thanks,

    Jmak209

Viewing 3 posts - 1 through 3 (of 3 total)