Emporia Community

Community Forum for Emporia

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: Configuring Main 200A sensors for branch circuits #8081 Report Abuse
    takis7
    Member

    I was disappointed to see that this issue wasn’t addressed on the latest App update (v3.0).

    Is there any chance this will be implemented anytime in the near future?

    in reply to: Configuring Main 200A sensors for branch circuits #6751 Report Abuse
    takis7
    Member

    Is there an update on this issue?

    I noticed that on the FAQ page it says:

    Do I need to install the 200A Main sensors for the 50A sensors to work?

    No, the 200A Main clamps for the Vue are not necessary for the individual circuit sensors to work and the 200A sensors can be used to monitor another circuit.

    In my case, I want to use the 50A sensors to monitor individual circuits and the 200A sensors to monitor a circuit that goes to a subpanel.

Viewing 2 posts - 1 through 2 (of 2 total)